Have you ever wondered how to install a video door phone? It is common that you have some type of intercom in your block of flats, in isolated houses or similar, but surely you have ever thought of installing something more complete and with better features.
It is also normal that you do not know how to do it, and at this point, the best thing, without a doubt, is to resort to a good approved installer. You can also do it yourself by following the steps below.
How to install a video door entry easily?
A video door entry system is a video communication system that allows the person who is in the house to connect with the entrance door. In this way, you can visualize the outside of the home and communicate with it.
First of all, you must take into account the regulations regarding works of the Horizontal Property Law and the data protection regulations.
– First step: if there is no hole to insert the cables you will need and their protection tubes, which can be made of metal or PVC, you will have to open it between the area of the plate and the receiver.
Then, using some guides, you will have to introduce all the wiring inside the tubes, calculating the necessary length between the plate and the receiver, leaving at least 20 centimeters outside its channeling. Next, it will only be necessary to hide these tubes.
Remember to have them approved and relevant cables, as not all of them are suitable since they need to meet a series of very specific characteristics.
For example, the amount of thickness needed. Thus, when you want to be able to communicate up to 50 meters, you need a thickness of 0.6 mm. At larger distances, up to 1.5 mm is required. However, it is always advisable to consult the instruction manual of the device.
These cables must be connected to the electrical system of the building, so you must install them in an automatic of about 10 A minimum. At the same time, and in order to obtain the greatest possible safety, it is also recommended to have a 30 A differential.
– Second step: when the indoor receiver already has a transformer, you must connect it directly to any plug or general switch that is connected to the electrical system of the building.
In case you do not install the transformer directly to the phone, that is, in case it is independent, you should connect it to both the receiver and the power outlet mentioned above.
– Third step: after all this, it is necessary to make a recessed box where the plate that is located in the portal or the street will be installed.
For this, use a cold chisel and install it at a height of 1.60 meters. You must leave enough space to be able to embed both the tubes and the box where the plate plus the cement filler will be inserted, but always remember to wet the wall before applying it.
Let the cement dry and remove the screws from the recessed box as you see that they can no longer be obstructed with it. Then remove the excess cement and it is ready to be painted or restored to your liking to beautify it.
It is time to connect the plate inside the recessed box that contains the cables, leaving enough space to manipulate them.
Once inside the home, the last thing will be to mark the place on the wall where the receiver with the camera will go and drill to fasten it with screws using its grip plate.
Now you know how to successfully install a video door entry system! The video door entry system is a very important ally for your security because you will always be able to see what is happening at all times without being confused by the voice. Buy one right away and enjoy its advantages. Follow